Need help with fillingout all of your "Project Cards"?

Rachel Baxter formatted Microsoft Word documents to help.

You MUST complete your entry cards correctly, otherwise they will NOT be scanned.

Tape only at the top where it asks for it, use #2 pencil only, PRINT & bubble in ALL requested information, please put on the back School & Sponsor name.

*Student ID# = 1 per each student. Jill = 1; John = 2; Bill = 3, etc..

**Team entries = need ONLY 1 card for the whole team.

***Level 1 or 2, write down either 01 or 02 where it says ESC.

NOTE: When I print these out using laser printer, I put them in the manual feed - envelope setting, OR right in the center. You may have to experiment with yours until it works for you. I advise that you make say 10 photocopies to do test prints on. Since every printer is slightly different. If you only have a few kids who just do 1 or 2 projects, then "project cards" are easy for you. In my case I have one student who has 15 projects ready to go allready. Printing out his name, chapter #, student ID # saves us so much time. That's why I took the time to figure out this process. As of right now I have NOT updated for the new state cards. It's coming soon. Let me know if it helps or not! rbaxter@conroeisd.net

State Card FRONT

 

Any questions or comments please contact our webmistress Rachel Baxter rbaxter@conroeisd.net

Last updated April 8, 2008